2/18/2021 0 Comments How Does Solar Panel Installation Variables Vary Depending On The Condition Of The Roof? In general, residential solar panel installation typically follows this simple procedure: 1. Site Survey and Design. Time frame: 1 - 4 weeks. This phase starts with an on-site survey, in which your solar energy architect will visit you to obtain a more accurate picture of your individual requirements. Based on the survey results, your contractor can design and install residential solar panels on your roof. The rooftop survey is usually performed on flat roofs. On steeply angled roofs, or on structures that are susceptible to damage, the installation may extend beyond the rooftop. A representative from your solar energy company will typically be sent to your home for this purpose. The next step in the residential solar panel's installation process is to determine the best location for the installation. This is referred to as the site identification process. The optimal placement for the panel is determined by surveying the exterior angle of the house, looking at the amount of sunlight falling on the home, analyzing the lighting conditions from the front and back, and calculating the amount of heat energy expected to be generated by the panels. All of these factors are combined in order to create the most effective configuration for the panels to collect the maximum amount of sunlight. Roof installation is usually the last step in residential solar panels installation. To install blue raven solar panels on flat roofs, an installer will need to cut away a portion of the roof. This is done by gluing silicone tabs into the rafters of the home, then covering the seams with silicone rubber cement. If the roof is pitched or sloped towards the sun, then additional insulation must be applied to protect the electricity from being exposed to direct sunlight. Once the solar panels have been installed on the roof, they must be left to set up and start generating power for the home. This is usually done by a solar contractor. A solar contractor is a licensed, bonded professional that has been approved by the state to perform residential solar panel installation jobs. He is responsible for the inspection of the system and ensuring that it is set up properly. Solar contractor on this website: blueravensolar.com/south-carolina/columbia/ will also make sure that all the equipment and wiring are placed in the proper location and can supply the electricity that is needed when the sun goes down. In order to ensure that the residential solar panel installation process varies depending on the condition of the roof, it is recommended that a solar contractor also inspect the attic. There are typically cracks in the rafters and insulation that can allow rain water to leak into the attic, which can create moisture issues. An experienced solar contractor can inspect the roof and make recommendations to eliminate the risk of having the roof damaged or destroyed during the course of the solar energy project. Add on to your knowledge about this topic, by visiting this link: https://en.wikipedia.org/wiki/Photovoltaics.
0 Comments
Leave a Reply. |
|